Panasonic VIERA TH-P55VT60A Operating Instructions Manual

Also see for VIERA TH-P55VT60A: Quick guide

Contents

Panasonic VIERA TH-P55VT60A Operating Instructions Manual Manual pdf 19 page image

191 Turn the 3D Eyewear on and put it onConnection status and battery status are displayed on the bottom right of the screen.2 View the 3D imagesSafety precautions will be displayed when you first watch the 3D image. Select [Yes] or [No] to continue to view3D images.Note● Turn off the 3D Eyewear after using it.● Use the 3D Eyewear within approximately 3.2 m from the TV. You cannot view the 3D images with the 3D Eyeweartoo far from the TV, because of the difficulty of receiving radio waves from the TV.● The range may be shortened depending on the obstacles between the TV and the 3D Eyewear, or the surroundingenvironment.● Use the 3D Eyewear where there is no interference from other Bluetooth devices.● 3D content will not be correctly visible if the 3D Eyewear is worn upside down or back-to-front.● When viewing 3D images, make sure your eyes are at an approximately horizontal level and keep a position whereyou do not see double images.● If light appears to flicker under fluorescents or dimmers when using the 3D Eyewear, change the setting of [3DRefresh Rate] in [3D Settings] (Picture Menu).● There are differences in the viewing range of the 3D Eyewear among individuals.FAQsBefore requesting service or assistance, please follow these simple guides to solve the problem.● For more information, refer to [eHELP] (Support > FAQs).The TV does not switch on● Check the mains lead is plugged into the TV and the socket outlet.The TV goes into Standby mode● Auto power standby function is activated.The remote control does not work or is intermittent● Are the batteries installed correctly? (p. 11)● Has the TV been switched on?● The batteries may be running low. Replace them with new ones.● Point the remote control directly at the TV’s remote control signal receiver (within about 7 m and a 30 degreeangle of the signal receiver).● Situate the TV away from sunshine or other sources of bright light not to shine on the TV’s remote control signalreceiver.Electronic Touch Pen does not work● Check that the batteries are fresh, are of the same type and are installed with the correct polarity (+ & -).● Check if the pairing range is within 50 cm.● The Electronic Touch Pen automatically turns off if pairing cannot be performed within 2 minutes. In this case, pairagain.● The Electronic Touch Pen automatically turns off if unused for 5 minutes.(When the Electronic Touch Pen is turned on, the indicator lamp blinks but turns off in several minutes.) Turn thepower on again.No image can be displayed● Check the TV is turned on.● Check the mains lead is plugged into the TV and the socket outlet.● Check the correct input mode is selected.● Check the setting of [AV] ([COMPONENT] / [VIDEO]) in [Input Selection] to match the output of the externalequipment.● Is [Contrast], [Brightness] or [Colour] in the Picture Menu set to the minimum?● Check all required cables and connections are firmly in place.Unusual image is displayed● Turn the TV off with Mains power On / Off switch, then turn it on again.● If the problem persists, initialise all settings. [Shipping Condition] in [System Menu] (Setup Menu)● Image retention images may be reduced / removed by [Scrolling Bar] in [Screen Settings] (Picture Menu).