14First-time OperationGetting StartedUseful InformationTroubleshootingAppendixSlide and hold the power switch for approximately one second until thepower indicator lights.CAUTIONz Do not slide the power switch repeatedly.z The computer will forcibly be turned off if you slide and hold the power switch forfour seconds or longer.z Once you turn off the computer, wait for ten seconds or more before you turn onthe computer again.z Do not perform the following operation until the hard disk drive indicator turns off.• Connecting or disconnecting the AC adaptor• Sliding the power switch or CD/DVD drive power/open switch• Touching the keyboard or touch pad• Closing the displayz Do not change the Setup Utility until completing step 5. If you do so, Windowssetup may not operate properly.Follow the on-screen instructions.z After turning on the computer, “Please wait a moment while Windows pre-pares to start for the first time .........” appears, and then a small circle circu-lates on the screen. This will take a few minutes.z During setup of Windows, use the touch pad to move the cursor and to clickan item.z Do not change the settings on the screen where you select a country orregion. You can set a country, region or keyboard layout in [Clock, Language,and Region] of [Control Panel] after the Windows setup is complete.z Setup of Windows will take approximately 20 minutes.Go to the next step, confirming each message on the display.CAUTIONz You cannot choose the following words for user name and password: CON,PRN, AUX, CLOCK$, NUL, COM1 to COM9, LPT1 to LPT9.z You can change the user name, password, image and security setting aftersetup of Windows.z Remember your password. If you forget the password, you cannot use the Win-dows. Creating a password reset disk beforehand is recommended.Î Reference Manual “CD/DVD Drive”NOTEz PC Information ViewerThis computer periodically records the management information including the hard disk information such as numberof hours powered-on, number of times powered-on, internal temperature, replacement sector. The maximum datavolume for each record is 750 byte. These information are only used for estimating the cause when the hard diskgoes down by any possibility. They are never sent to outside via network nor used for any other purpose except forthe purpose described the above.To disable the function, add the check mark for [Disable the automatic save function for management informationhistory] in [Hard Disk Status] of PC Information Viewer, and click [OK].When you disable the function, information on how to use the hard disk is not displayed.(Î Reference Manual “Check the Computer’s Usage Status” and Hard Disk Handling)z If you hear the sounds from CD/DVD driveIn the following situations, the sounds from the CD/DVD drive can be heard.• Immediately after the CD/DVD drive is turned on• Just after turning on the computer with [DVD Drive Power] set to [On] in the Setup Utility• When a CD or DVD is playingThe sounds you hear are normal operating sounds created by the motor in the CD/DVD drive operating; it is not amalfunction.4 Turn on the computer.It takes approximately 5 minutes until the Windows setup screen appears. Do nottouch the keys and touch pad until it appears.5 Setup Windows.6 Change the internal CD/DVD drive letter if necessary.4