Panasonic Toughbook CF-T7BWATAAM Operating Instructions Manual

Also see for CF-T7 Series: Operating instructions Supplementary guide Supplementary guide Operating instructions Specification

Contents

Panasonic Toughbook CF-T7BWATAAM Operating Instructions Manual Manual pdf 14 page image

14First-time OperationGetting StartedUseful InformationTroubleshootingAppendixThe battery charging starts automatically.CAUTIONz Do not disconnect the AC adaptor and do not switch the wireless switch to onuntil the first-time operation procedure is completed.z When using the computer for the first time, do not connect any peripheral deviceexcept the battery pack and AC adaptor.z Handling the AC adaptor• Problems such as sudden voltage drops may arise during periods of thunder andlightning. Since this could adversely affect your computer, an uninterruptible powersource (UPS) is highly recommended unless running from the battery pack alone.Slide and hold the power switch for approximately one second until thepower indicator lights.z When the power is turned on, the power indicator lights. But, in the following cases,the power indicator may turn off once immediately after the power is turned on.• After removing the battery pack and the AC adaptor and setting them again• After sliding the power switch for four seconds or longer and turning off the powerCAUTIONz Do not slide the power switch repeatedly.z The computer will forcibly be turned off if you slide and hold the power switch forfour seconds or longer.z Once you turn off the computer, wait for ten seconds or more before you turn onthe computer again.z Do not perform the following operation until the hard disk drive indicator turns off.• Connecting or disconnecting the AC adaptor• Sliding the power switch• Touching the keyboard, touch pad or touchscreen• Closing the displayz Do not change the Setup Utility until completing step 5. If you do so, Windowssetup may not operate properly.z The input panel is displayed on “Welcome to the Windows XP Setup Wizard”.Move “Welcome to the Windows XP Setup Wizard” and make sure that the “Wel-come to the Windows XP Setup Wizard” and the input panel do not overlap.Follow the on-screen instructions.z The computer will restart after the setup is complete.To go to the next step, wait until the hard disk drive indicator has turned off.CAUTIONz When you set date/time/time zone and click [Next], the screen may not go to thenext step for a few minutes. Do not touch the keyboard, touch pad or touch-screen, and wait until the screen changes.z When using the included stylus, avoid touching the screen with you hands, etc.This can cause input errors.z At “Welcome to Tablet PC”, you can learn the basic operations of Windows XPTablet PC Edition.3 Connect your computer to a power outlet.4 Turn on the computer.5 Setup Windows.34