Panasonic Toughbook CF-48 Series Reference Manual

Also see for Toughbook CF-48 Series: Reference manual Operating instructions Service manual Reference manual Operating instructions

Panasonic Toughbook CF-48 Series Reference Manual Manual pdf 49 page image

49Technical InformationNetworkWhen the power saving function is running, communications software may malfunc-tion. For example, communications may be halted if the standby (hibernation) modeis activated. The computer must be restarted if one of these modes is entered duringdata communications.Be sure that the power of the display is cut (for energy conservation purposes) or thecomputer enters standby (hibernation) mode after the communications software isclosed.The network connection may be severed under the condition thepower of the display is OFF (for energy conservation purposes) andstandby (hibernation) mode. When network or communication soft-ware is to be used, set [System standby], [Turn off monitor] and [Turnoff hard disks] (in [Start] - [Settings] - [Control Panel] - [Power Man-agement]) to [Never].The network connection may be severed when entering the ECOmode and standby (hibernation) mode. Be sure to disable the[Standby/Hibernation Timeout]* settings with the Setup Utility if yourequire a network environment. The computer will not operate prop-erly. If this occurs, restart the computer.* Since access to the hard disk occurs often on Windows NT, standby/hibernationtimeout may not function according to the set times. However, be sure to set OFF justto be safe.The network connection may be severed under the condition thepower of the display is OFF (for energy conservation purposes) andstandby (hibernation) mode. When network or communication soft-ware is to be used, set [System standby] and [System hibernates],[Turn off monitor] and [Turn off hard disks] (in [Start] - [Settings] -[Control Panel] - [Power Options]) to [Never].Windows 98Windows NTWindows 2000When Adding New Software or Hardware ComponentsSome of the contents of Service Pack 6 (installed at the time of purchase) may beoverwritten. Therefore, after adding a new software or hardware component, be sureto install (UPDATE) Service Pack 6. (See the c:\sp6\readme.htm file.)In addition, if you install Service Pack 6, some files of Phoenix APM 2.0 for WindowsNT® and Phoenix Card Executive 2.0 for Windows NT ® may be overwritten. There-fore, after installing Service Pack 6, also re-install Phoenix APM 2.0 for Windows NT ®and Phoenix Card Executive 2.0 for Windows NT ® .At times you may be prompted to copy Windows NT ® files. Input [c:\winnt\i386] asthe copy source and select [OK].In [Start]-[Run], input [c:\sp6\sp6i386.exe], then press [OK]. Follow the on-screeninstructions.Windows NT