3 Getting StartedRead Me FirstModels for U.S.A.Federal Communications Commission Radio Fre-quency Interference StatementNote: This equipment has been tested and found to com-ply with the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interfer-ence in a residential installation. This equipment gener-ates, uses and can radiate radio frequency energy and, ifnot installed and used in accordance with the instructions,may cause harmful interference to radio communications.However, there is no guarantee that interference will notoccur in a particular installation. If this equipment doescause harmful interference to radio or television recep-tion, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct theinterference by one or more of the following measures:z Reorient or relocate the receiving antenna.z Increase the separation between the equipment andreceiver.z Connect the equipment into an outlet on a circuit dif-ferent from that to which the receiver is connected.z Consult the Panasonic Service Center or an experi-enced radio/TV technician for help.WarningTo assure continued compliance, use only shielded inter-face cables when connecting to a computer or peripheral.Also, any changes or modifications not expressly ap-proved by the party responsible for compliance could voidthe user’s authority to operate this equipment.FCC RF Exposure Warning:z This equipment is provided with PC Card slot that couldbe used with wireless transmitters, which will be specifi-cally recommended when they become available.Other third-party wireless transmitters have not beenRF exposure evaluated for use with this computer andmay not comply with FCC RF exposure requirements.z This equipment complies with FCC radiation exposurelimits set forth for an uncontrolled environment.z This equipment has been approved for portable op-eration, and does not require any minimum spacing beprovided between antennas and all person’s body.If provided with wireless WAN transmitter, requires LCDside panel spacers to provide minimum 1.5 cm spacingbetween antenna located within the LCD side panel,and all person’s body (excluding extremities of hands,wrist and feet) during wireless modes of operation.z This equipment may not be co-located or operatedwith any other antenna or transmitter.z This equipment is provided with external antennaconnector(s) for connection to optional Car Mount-er or Port Replicator for mobile external mountedantenna(s). External antenna(s) must be profession-ally installed and cannot exceed recommended maxi-mum antenna gain as described in individual providedsupplement instructions for wireless transmitters.For WLAN, the Car Mounter should be usedwith Radiall/Larsen WLAN whip antenna, typeNMO5E2400BKTNC with 5 dBi antenna gain or less.Also, user must maintain minimum 20 cm spacingbetween external antenna(s) and all person’s body(excluding extremities of hands, wrist and feet) duringwireless modes of operation. 25-M-1FCC RF Exposure Warning:z This equipment is provided with external antennaconnector(s) for connection to optional Car Mounter orPort Replicator for mobile external mounted antenna(s).External antenna(s) must be professionally installedand cannot exceed recommended maximum antennagain as described in individual provided supplementinstructions for wireless transmitters. The Car Mounteris provided with Radiall/Larsen WLAN whip antenna,type NMO5E2400BKTNC with 5 dBi antenna gain.The maximum allowable antenna gain for the externalWWAN base whip antenna for the cellular band is 1.50 dBiand PCS band is 2.50 dBi. Also, user must maintain mini-mum 20 cm spacing between external antenna(s) and allperson’s body (excluding extremities of hands, wrist andfeet) during wireless modes of operation. 32-M-1This product is restricted to indoor use due to its operationin the 5.15 to 5.25 GHz frequency range. FCC requires thisproduct to be used indoors for the frequency range 5.15 to5.25 GHz to reduce the potential for harmful interferenceto co-channel Mobile Satellite systems. High power radarsare allocated as primary users of the 5.25 to 5.35 GHz and5.65 to 5.85 GHz bands. These radar stations can causeinterference with and/or damage this product. 25-M-W-1This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, in-cluding interference that may cause undesired operation.Responsible Party: Panasonic Corporation of North AmericaOne Panasonic WaySecaucus, NJ 07094Tel No:1-800-LAPTOP5(1-800-527-8675)6-M-1FCC Regulation Notice for modemThis equipment contains a FCC approved modem.1. This equipment complies with CFR47 Part 68 rules. Onthe computer is a label that contains, among other infor-mation, the FCC registration number and ringer equiva-lence number (REN) for this equipment. If required, thisinformation must be provided to the telephone company.2. An FCC compliant telephone cord and modular plug isprovided with this equipment. This equipment is designedto be connected to the telephone network or premiseswiring using a compatible modular jack which is Part 68compliant. See Installation Instructions for details.3. The REN is used to determine the quantity of deviceswhich may be connected to the telephone line. Ex-cessive RENs on the telephone line may result in thedevices not ringing in response to an incoming call. Inmost, but not all area, the sum of RENs should not ex-ceed five (5.0). To be certain of the number of devicesthat may be connected to a line, as determined by thetotal RENs, contact the local telephone company.
