Panasonic Touchbook CF-17 series Reference Manual

Also see for CF-17: Operating instructions Supplementary instructions Reference manual Supplementary instructions

8Operate while holding down the two buttons.Ctrl + M a g n i f yR e d u c eP a n*Scroll in various directions of adocument(move the mouse slightly whileholding down the wheel)Z o o m *Magnify/reduce the display ofa document.(rotate the wheel while holdingdown Ctrl )Data Zoom*Display or hide a document, orperform operations to return to orproceed with Internet Explorer.(rotate the wheel while holdingdown Shift )F u n c t i o n Touch Pad OperationShift +(To next page)Touch Pad (Advanced)CAUTIONW ithin the parentheses () are operations to follow when using an external Microsoft®IntelliMouseTM.* Indicates that the movements will differ depending on the application.When an external mouse or trackball with additional functions (e.g., wheel func-tion) is connected, a part or all of the additional functions may foil to operate. Touse these additional functions, install the driver or application software of theexternal device by following the procedure below. However, once the driver orapplication software is installed, touch pad functions (e.g., auto scroll) may notoperate even if the touch pad is enabled (see the procedure for “When you wantto re-enable the touch pad.”).1 In [Control Panel] - [System] - [Device Manager], select [touch pad] in [Mouse],press [Remove] to delete it, then press [OK] to confirm the deletion.2 Power off your computer and connect the external mouse or trackball device tothe computer.3 Turn the power on and run the Setup Utility ( page 37). In [Main] menu, set[Touch Pad] to [Disable] and close the Setup Utility.4 Following the operating instructions for the connected external mouse, installthe necessary driver.After the installation, set [Touch Pad] to [Disable] in the Setup Utility.Do not enter the suspend or hibernation mode when an external mouse is con-nected to the serial port.When you want to re-enable the touch pad;1 In [Control Panel] - [System] - [Device Manager], when an external mouse ortrackball device is displayed in [Mouse], press [Remove] to delete it, and thenpress [OK] to confirm the deletion.2 Power off your computer and remove the external mouse or trackball device.3 Turn the power on and run the Setup Utility ( page 37). In [Main] menu, set[Touch Pad] to [Enable] and close the Setup Utility.4 Confirm whether [touch pad] exists in [Mouse] (in [Control Panel] - [System] -[Device Manager]).W h e e lW h e e lW h e e l