Panasonic TY-WK65PV7 Installation Instructions Manual

Contents

installation procedure

Panasonic TY-WK65PV7 Installation Instructions Manual Manual pdf 4 page image

9 EnglishInstallation procedureThe wall-hanging bracket weighs approximately 9 kg (19.8 lbs.) and the Plasma Display unit weighsapproximately 78 kg (172.0 lbs.) to 95 kg (209.4 lbs.).While referring to the wall-hanging bracket installation dimensions in the diagram below, check the strength ofthe wall in six installation locations, and add reinforcing if any of these locations are not strong enough.1. Check the strength of the installation location.• Install the Wall-hanging bracket so that the arrow shown on the bracket is pointing upwards.• If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracketitself to determine the correct installation hole positions, or use the dimension diagram to calculate the holepositions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow thebolts to protrude from the wall by 10 mm (13/32 inches) to 15 mm (19 /32 inches).2. Install the wall-hanging bracket to the wall.Installation procedure1. First screw a bolt into the center-tophole.2. Use a level gauge to correct thealignment of the wall-hanging bracket,and then screw bolts into theremaining five holes.3. Provisionally tighten the fixing screws.If the screws are inserted more than 5mm (13 /64 inches), it will not be possibleto install the Plasma Display in thecorrect position.1320 (51 31 / 32 )644.6 (25 3/ 8 ) 644.6 (25 3 / 8 )15.4( 39 / 64 )15.4( 39 / 64 )570 (22 7 / 16 )17( 43 / 64 )17(43 / 64 )604 (23 25 / 32 )• The wall-hanging bracket hasinstallation holes provided in 14locations.if the wall material will not allowsufficient strength to be obtained fromusing six installation holes, use some ofthe spare holes.However, depending on theconstruction material used at the placeof installation, cracks may develop ifthe screws are inserted too close toeach other.Caution• Use commercially-available M6 boltswhich suit the wall materials forinstallation to the wall.Caution• The marks indicate the centerline of thePlasma Display.Wall installation holes (6 locations)Units: mm (inches)Horizontal installationVertical installationMarks (H)Marks (V)Marks (V)Fixing screw(M5-133)Fixing screw(M5-133)Fixing screw(M5-133)Note