Panasonic TY-TPEN6 - Stylus - Wireless Operating Instructions Manual

Also see for TY-TPEN6 - Stylus - Wireless: Service manual Service manual

Contents

Panasonic TY-TPEN6 - Stylus - Wireless Operating Instructions Manual Manual pdf 6 page image

6Battery capFunction switchPen tipPress this to use the funcions thatcan be set in “Touch Panel SettingProgram” menu.(Please refer to the operatinginstructions of touch panel)Pressing the pen tip performs thesame operation as clicking theleft button of the PC mouse.AccessoriesBattery installationHow to install BatteriesPrecautions on battery useIncorrect installation can cause battery leakage andcorrosion that will damage the touch pen.Observe the following precautions:1. Batteries should always be replaced as a pair. Alwaysuse new batteries when replacing the old pair.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon”with “Alkaline”).4. Do not attempt to charge, short-circuit, disassemble,heat or burn used batteries.Touch Pen• Never attempt to disassemble or modify this product.To avoid fire, shock, or failure.• Be careful not to grasp the infrared-ray-emitting area of the touch pen while using it. This may result inincorrect operation.• Do not press the pen tip down with excessive force.• The pen may not work correctly if there is an intense light source or equipment employing infrared raysnearby. Keep as far away from such light sources as possible.• Do not operate the touch pen simultaneously with the remote control for a TV or VCR. Incorrect operationmay result if operated simultaneously.• If the touch pen surface becomes soiled, gently wipe off the soiling with a soft cloth.If the surface becomes extremely soiled, soak a cloth in neutral detergent diluted with water, wring out the clothwell, wipe off the surface with the cloth, and then finish by wiping with a dry cloth. Be careful not to let water dropsget inside the equipment, as this may cause it to malfunction.• If the touch pen will not be used for a long time, remove the batteries to conserve their energy.Pen tip (3) battery (2)Naming / UsePull out the old pen tip andreplace with a new one.If the pen tip becomes worn ordamaged, replace with thereplacement tip included.Touch pen tip replacement method1 Remove thebattery cap. 2 Insertbatteries.3 Refit thebattery cap.Rotate the capcounter-clock-wiseto remove.Be sure to insertwith the correctorientation.Rotate the capclockwise torefit.This product is intended for use only with a touch panel.WarningsTurn on the selection switch at the rear of the touchpanel.Infrared-ray-emitting area