Panasonic TY-TP50P10S - Touch-screen - Wired Operating Instructions Manual

Also see for TY-TP42P10S - Touch-screen - Wired: Operating instructions Service manual

Panasonic TY-TP50P10S - Touch-screen - Wired Operating Instructions Manual Manual pdf 11 page image

11Installation & SetupMounting Touch Panel (in Vertical Posture)1 Attach mounting brackets to the touch panel.㊍ Fit the protrusions on the vertical mounting brackets into the holes of the unit and affix the bracketswith mounting screws B.㊎ As shown in the diagrams, tighten mounting screws A by hand to temporarily hold the brackets A and Bafter fitting the protrusions located above the round holes on both brackets into the holes of the top andbottom units. Screw mounting screws A into the top and bottom units half way.Vertical mounting bracketsTop unit Bottom unitMounting screws BScrew in halfwayProtrusionMountingbracket AMountingbracket BMounting screws AScrew in halfwayProtrusion㊍㊎Mountingscrews A㊎2 Attach the touch panel to the front of the plasma display.㊍ To attach the touch panel to the plasma display, align the top and bottom edges of the touch panelwith the top and bottom edges of the plasma display. Once attached, adjust the fit so that the left andright black frames on the front of the plasma display are the same width.Notes on Assembly• Work in twos or more to attach the touch panel to the plasma display. If thetouch panel is dropped, injuries may occur.• Because it can damage the infrared sensor of the touch panel, do not lay thetouch panel down and attach the plasma display to it from above. Service fordamage caused by installation in this way is subject to billing.FloorPlasma displayTouch panelINCORRECT