Panasonic TY-TP42P6S Operating Instructions Manual

Contents

Panasonic TY-TP42P6S Operating Instructions Manual Manual pdf 10 page image

10Connection between the computer and plasma displayUSBPenOFF ONConnection with computer∗ Check that the USB power supply of the computer being used is rated at 500 mA.(1) Connect the plasma display and computer with the VGA cable.(2) Turn on power in the following sequence: 1: Plasma Display, 2: Computer.(3) Switch the plasma display input signal to the computer.(4) After the computer OS starts up, connect the touch panel and computer with the USB cable.(5) Insert the CD-ROM containing the USB driver into the CD drive of the computer, start the install wizard, and installthe USB driver software by following the instructions on the screen.Notes:• After the computer OS has finished starting up, connect the USB cable.• If you connect using a USB hub, you must supply power to the USB hub.• For details on USB driver software setup, see “USB driver setup.” (See below)• After USB driver setup, you must set up the touch panel driver software. (See page 21)• If the infrared transmissive part of the screen is accidentally obstructed (such as by your finger) while connecting theUSB, an element defect will be detected. If you use the system in that state, it may respond poorly to touch. If thishappens, remove the USB cable and insert it again. You do not need to restart the computer.USB cableInstallation of the USB driverIn case of Windows 98 / Second Edition (SE) .......... page 12In case of Windows Millennium Edition (ME) ............ page 14In case of Windows 2000 .......................................... page 16In case of Windows XP ............................................. page 18Plasma Display (Rear view)Touch PanelComputerUSB connector