13■ Driver Software Operating EnvironmentThe Driver software is supported by both the Japanese and English versions of Windows XP (SP3 or later),Windows XP x64 Edition (SP2 or later), Windows Vista (SP1 or later), Windows Vista x64 Edition (SP2 orlater), Windows 7, and Windows 7 x64 Edition.* Windows is a registered trademark of Microsoft Corporation in the USA and other countries.The following environment is required to correctly install and start up the Driver software.• CPU … Pentium IV or later(2 GHz or faster Celeron or Pentium 4recommended)• Memory … 512 Mbytes or more• HDD … 150 Mbytes or more available area• Compatible with USB 1.1/2.0 interface■ Driver Software Restrictions• The mouse emulation feature cannot be used on the login window that appears at Windows startup, whenrestoring from the suspended state or when the screen saver is unlocked. The mouse emulation feature isactivated after you log in.• There is no remote wakeup feature that activates the screen from the suspended state by touching thetouch panel.• If your system does not meet the requirements above or the applications use up too much memory, theresponse of the touch panel may slow down.• Only Windows is supported. (Operation is not guaranteed in other environments than the above.)• If using Windows Vista/7 and user account control, the touch panel does not respond to touch whenwindows, such as the Properties window, that require administrator authority to access appear.■ Restrictions on competing drivers• If you try to install a driver from another manufacturer in the same computer in which this Driver softwareis installed or inversely try installing this Driver software in a computer where another driver is alreadyinstalled, the driver may not install properly.In such case, uninstall the current driver and then install the new driver.Also, if a driver from another manufacturer is started up while this Driver software is already running, theerror message “A driver is already running.” may be displayed.In such case, quit both drivers and then start up the driver you want to use.• Windows XP x64 Edition computer with physical memory of 6 GB or greater should be connected via aUSB 2.0 hub with power supply.Depending on your environment, a USB hub with power supply may be required regardless of thecondition above.7 x64 Edition>• CPU … Intel Core 2 Duo or later• Memory … 2 GB or more• HDD … 150 Mbytes or more available area• Compatible with USB 1.1/2.0 interfaceInstallation & SetupSetup ProcedureConnect the touch panel and computer (P. 16)Restart your computer31 Install the Driver Software (P. 14)Do not connect the USB cable yet.• After restarting your computer, check appears in the task tray.• If the icon does not appear, if it appears with an X over it or if an error message is displayed,see “Before Calling for Service” (p. 40) and “Error Messages”. (p. 42)23Calibrate the touch panel (P. 27)4This completes the basic setup.4
