Panasonic TX-P50X50E Operating Instructions Manual

Also see for Viera TX-P42X50E: Operating instructions

Contents

Panasonic TX-P50X50E Operating Instructions Manual Manual pdf 10 page image

English10Auto SetupSearch and store TV channels automatically.These steps are not necessary if the setup has been completed by your local dealer.Please complete connections (p. 8, 9) and settings (if necessary) of the connected equipment before starting AutoSetup. For details of settings for the connected equipment, read the manual of the equipment.1 Plug the TV into mains socket and switch onTakes a few seconds to be displayed.If the red LED shows on the TV, press the Standby On / Off switch on theremote control for about 1 second.2 Select the languageMenüspracheDeutsch Dansk Polski SrpskiEnglish Svenska HrvatskiFrançais Norsk Magyar Italiano Suomi Español Türkçe eesti keelPortuguês !" #$% & 'Nederlandsselectset3 Select your countryCountryGermany Denmark PolandAustria Sweden CzechFrance Norway HungaryItaly Finland SlovakiaSpain Luxembourg SloveniaPortugal BelgiumEstoniaSwitzerland NetherlandsLithuaniaMalta TurkeyOthersAndorra GreeceCroatiaselectsetDepending on the country you select,select your Region or store the Child Lock-PIN number (“0000” cannot be stored) byfollowing the on-screen instructions.4 Select the mode to tuneDATV Signal SelectionDVB-CDVB-TAnalogueStart Auto Setupselecttune / skip tuning: tune (search for the available channels): skip tuning5 Select [Start Auto Setup]DATV Signal SelectionDVB-CDVB-TAnalogueStart Auto SetupselectaccessAuto Setup will start to search for TV channels and store them.The stored channels and sorted channel order vary depending on the country, area,broadcasting system and conditions of signal reception.Auto Setup screen varies depending on the country you select.1 [DVB-C Network Settings]Depending on the country you select, select your cable provider beforehand byfollowing the on-screen instructions.DVB-C Network SettingsFrequency AutoNetwork IDStart Auto SetupAutoselect[Start Auto Setup]accessNormally set [Frequency] and [Network ID] to [Auto].If [Auto] is not displayed or if necessary, enter [Frequency] and [Network ID] specifiedby your cable provider with numeric buttons.