Note● TV Guide may also be used to set timer event.Watching > TV Guide > Timer Programming● Timer Programming can store up to 15 events.● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● For recording using Timer Programming, the TV must be either on or inStandby.● Depending on the progress of recording, analogue channel may not beselected. [Only for dual tuner model]● No other channels can be selected while recording of Timer Programmingis in progress. [Only for single tuner model]● Recording an encrypted (copy-protected) programme may not be possible.● When the start time comes, the channel may be switched automaticallyand the video and audio signals may be output. 2 minutes before the starttime, a reminder message may appear if you are watching TV. [Only fordual tuner model]● When the start time comes, the channel will be switched automatically andthe video and audio signals will be output. 2 minutes before the start time,a reminder message appears if you are watching TV. [Only for single tunermodel]– To remove the message and start the programming, press OK.– To cancel the programming, press EXIT.● LED turns to orange in Standby mode when Timer Programming is set.● “!” identifies that three or more timer events are overlapped. As forthe overlapped recording events, the first event starts and finishes asprogrammed. The next event can then start. [Only for dual tuner model]● “!” identifies that two or more timer events are overlapped. As for theoverlapped recording events, the first event starts and finishes asprogrammed. The next event can then start. [Only for single tuner model]● The recording of Timer Programming may automatically change thechannel to the programmed channel a few seconds before the start time.[Only for dual tuner model]● The recording of Timer Programming automatically changes the channelto the programmed channel a few seconds before the start time. [Only forsingle tuner model]● For details of the USB HDDRecording > Technical information- 146 -
