Note● TV Guide may also be used to set timer event.Watching > TV Guide > Timer Programming● Timer Programming can store up to 15 events.● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● For recording using Timer Programming, the TV must be either on or inStandby.● No other channels can be selected while recording of Timer Programmingis in progress.● Recording an encrypted (copy-protected) programme may not be possible.● Depending on the network condition, recording function may not workproperly in DVB-via-IP.● When the start time comes, the channel will be switched automatically andthe video and audio signals will be output. 2 minutes before the start time,a reminder message appears if you are watching TV.– To remove the message and start the programming, press OK.– To cancel the programming, press EXIT.● LED turns to orange in Standby mode when Timer Programming is set.● “!” identifies that two or more timer events are overlapped. As for theoverlapped recording events, the first event starts and finishes asprogrammed. The next event can then start.● The recording of Timer Programming automatically changes the channel tothe programmed channel a few seconds before the start time.● For details of the USB HDDRecording > Technical information- 124 -
