Panasonic TX-36PF10P Service Manual

Also see for TX-32PF10P: Operating instructions

ALIGNMENT SETTINGS:(The figures below are nominal and used for representative purposes only.)1. Set the Bass to maximum position, set the Treble to minimum position, press the down button (- / v) on the customercontrols at the front of the TV and at the same time press the INDEX button on the remote control, this will place the TVinto the Service Mode.2. Press the RED / GREEN buttons to step up / down through the functions.3. Press the YELLOW / BLUE buttons to alter the function values.4. Press the STR button after each adjustment has been made to store the required values.5. To exit the Service Mode, press the "N" button.Alignment Function Settings / Special featuresHorizontal Position H-Pos+020Optimum setting.Vertical Position V-Pos+024Optimum setting.Horizontal Amplitude H-Amp+049Optimum setting.Vert. Amplitude V-Amp+029Optimum setting.EW-amplitude E/W-Amp1+022Optimum setting.EW-amplitude E/W-Amp2+000 Optimum setting.Trapezium-comp Trapez-1+033Optimum setting.Horizontal-Parallel H-Parallel+032Optimum setting.Vertical Linearity V-Lin+004Optimum setting.DVCO DVCO000Receive a PAL Colour Bar Pattern. ForDVCO alignment press "Blue" button, waituntil the colours are stable and press"STR".Cut-off DC Cut-offO.K.To adjust Cutoff adjust the screen VR untilthe display shows "O.K."Highlight High 0031 0031 0031Contrast MaximumA.I. OffAdjust for optimum setting.Sub-Brightness Sub-Brightness000Optimum setting.7