Panasonic TX-32PX10D Service Manual

Also see for TX-28PX10D: Operating instructions Service manual

Contents

Panasonic TX-32PX10D Service Manual Manual pdf 3 page image

ALIGNMENT SETTINGS(The figures below are nominal and used for representative purposes only.)1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press thedown button (-/v) on the customer controls at the front of the TV and at the same time press the INDEX button on theremote control, this will place the TV into the Service Mode 1.2. Press the RED / GREEN buttons to step up / down through the functions.3. Press the YELLOW / BLUE buttons to alter the function values.4. Press the STR button after each adjustment has been made to store the required values.5. To exit the Service Mode, press the "N" button.Alignment Function Setting indicationNote: All setting values are approximate Settings / Special featuresHorizontal Position H-Pos21 Optimum setting.Vertical Position V-Pos27 Optimum setting.Horizontal Amplitude H-Amp41 Optimum setting.Vert. Amplitude V-Amp-66 Optimum setting.EW-amplitude EW-Amp 1- 25 Optimum setting.Lower Corner Lower Corner2 Optimum setting.Trapezium-comp Trapez 1-7 Optimum setting.Upper Corner Upper Corner-2 Optimum setting.Vertical Symmetry V-Sym-4 Optimum setting.Vertical Linearity V-Lin40 Optimum setting.Angle Angle-2 Optimum setting.Bow Bow0 Optimum setting.DVCO DVCO-1Receive a PAL Colour Bar Pattern. ForDVCO alignment press "Blue" button, waituntil the colours are changing slowly andpress "STR".HighlightLowlightHigh 0403 0318 0350Low 0071 0132 0160 Optimum setting.Sub-Brightness Sub-Brightness20 Optimum setting.6