Panasonic TX-26LXD52 Operating Instructions Manual

Also see for TX-26LXD52: Service manual Service manual

Contents

Panasonic TX-26LXD52 Operating Instructions Manual Manual pdf 7 page image

7Quick Start GuideProgrammes will appear immediately if your dealer has programmedthe TV for you.If the TV has not been programmed for you then Auto setup will begin.The TV will search for DVB stations and Analogue stations:TV stations will be located, sorted into order and stored ready for use.Stations are sorted into the following order:• DVB Stations: Are sorted by their logical channel number sent bythe broadcasters, which can be made the favourites list by ProfileEdit. See page 24.• Analogue Stations: Are sorted into channel order, but can bechanged to your preference. See page 15.In this setup, usually Analogue auto setup screen may not bedisplayed. The sorted programme order depends upon the TV signal,the broadcasting system, and reception conditions.21 Connect the mains plug to the wall socket.Press the [ ] switch on the TV set to turnthe set on.To switch the TV set to Standby mode, pressthe button on the remote control.The TV set can be switched on by pressingthe button again if it was in Standby mode.Note:This TV will still consume some power evenin the Off mode, as long as the mains plug isstill connected to a live mains socket.PULL1 2 34 5 67 8 90IDTVNMODEOKCRemote control signal sensorCH44AUTO SETUP IN PROGRESSSEARCHING : PLEASE WAIT21 68ExitDOWNLOAD IN PROGRESSPLEASE WAITProgramme : 63Remote control unavailablePlease Wait !DVB Aute SetupProg. Channel Service Name NetID. TS ID. QualityThis will take about 3 mins.Exit45678303030303012302123021230212302123024158415841584158415899999BBC NEWS 24BBCICBBC ChannelBBC Radio WalesBBC Radio Cymru6821TV to VCR or DVD Recorder DownloadIf a “Q-Link”, “NEXTVIEWLINK” or compatible recording device hasbeen connected to a Scart terminal (AV2 or AV4) before starting Step1, programme information will be downloaded to that device.Only the analogue programme positions will be downloaded to therecording device, in the same order as stored in the TV. See page 32.Not all VCRs / DVD Recorders support this download of programmeinformation, some may require to be started manually.3Refer to the recording device’s operating instruction book.If a recording device other than those described above has been connected, then there will be no download operation.Notes:• If the recording device has not accepted download data from the TV, you may need to select the Downloadoption from the device’s menu system. Refer to the recording device’s operating instruction book.• If Q-Link is not operating correctly, check the following:The Scart cable is connected to the TV’s Scart terminal, AV2 or AV4, and correctly setup in the menu.The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similartechnology) Scart terminal.The Scart cable is a “fully wired” type.• For further information on Q-Link and connecting equipment, see page 32, 40, 44.Power IndicatorStandby : RedOn : No LightC.A.T.S. sensorLCD C.A.T.S. (Contrast Automatic Tracking System)automatically senses the ambient light conditions andadjusts the brightness and gradation accordingly, tooptimize contrast. C.A.T.S. is in effect when Viewingmode is set to Auto. See page 11.DVB IndicatorDVB system active during Timerrecording or Direct TV Recording : Orange (flash)Timer Recording On : OrangeOtherwise : No Light