TV24Note• You cannot record the copy protected signals.• If the Off timer function is activated or press the Standby On / Off button on theremote control during recording, the recording will not stop.• Do not press the MAINS power On / Off switch on the TV during recording.Otherwise the file will be broken.• Do not remove the SD card while recording. The data being recorded andother data stored on the SD card may become unreadable.• SD recording may not be fully compatible or playable in some PC software orPDA devices.• When two pictures are shown on the same screen as Multi window functions,the main window is the one that is recorded. The picture can be switched forthe sub window (p. 11).• If the signal system is changed during recording, it cannot be recordedcompletely.• The signals without video (only audio) cannot be recorded completely.• For details (p. 35 and p. 38)Recording a Programme on SD CardWhile watching a programme2To stop3(During the confirmation message appears)The TV channels and AV1 input signals (PAL / SECAM) can be recorded on the SD card. Duringrecording, it is possible to watch other terminals input signal.• Recordable time is displayed if therecording time is not set. (p. 25)• Start recording• CancelStart recording?Not enough memoryCurrent settingRec time 180minRec mode EconomyRecordable at 15minCard capacity is not enough.• Continue(Recording is stopped whenthe card capacity is full.)• CancelŶShould such a message appearInsert the SD Card (p. 23)1This product is licensed under the MPEG-4 patent portfolio license for the personal and non-commercialuse of a consumer to (i) encode video in compliance with the MPEG-4 Video Standard (“MPEG-4 Video”)and/or (ii) decode MPEG-4 Video that was encoded by a consumer engaged in a personal and non-commercial activity and/or was obtained from a licensed video provider. No license is granted or impliedfor any other use. Additional information may be obtained from MPEG LA. See http://www.mpegla.com.