Panasonic TX-26LX1A Operating Instructions Manual

Also see for TX-26LX1A: Service manual Operating instructions

Panasonic TX-26LX1A Operating Instructions Manual Manual pdf 16 page image

16TuningPress the MENU button.Move to choose SETUP.Access SETUP.Move to choose TUNING MENU.Access TUNING MENU.Move to choose MANUAL TUNE.Access MANUAL TUNE.Select the programme position to be tuned.Press repeatedly until required station is found.When the desired station is found, press the OK button to store.The programme position will flash.Press the TV/AV button at any time to go back to watching TV.It is possible to retune individual programme positions:It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions:5. 5MHzCH 121MANUAL TUNE- , + : SEARCHTV / AV : MOVE CURSORSTR : TO STOREF : TO EXITSTR F - / + / TV / AVMANUAL TUNERETURN EXITSEARCH - /+PROGRAMME - /+ STORECH 121MENUOK1 2 34 67 8 90TVOK5Press F until TUNING MODE is reached.Press –/ or +/ to access TUNING MODE.Press F until MANUAL TUNE is reached.Press –/ or +/ to access MANUAL TUNE.Press TV/AV to move between Change programme, Searchand Change sound system.Press –/ or +/ to change programme position or start search.When the desired station is found, press STR to store.The programme position will flash.Repeat above procedure to tune additional programme positions.Press F at any time to exit the TUNING MENU.TV/AVMANUAL TUNE (via front panel)Notes:• If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the COLOUR SYSselection on page 13.• After the MANUAL TUNE is finished, press the Programme Number up button to confirm the tuning condition foreach Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.Please refer to the SKIP function on page 13.• When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cable asindicated in the instruction manual of VCR and to set the designated channel to Programme No.“0”. In that case,perform MANUAL TUNE after setting the COLOUR SYS and SOUND SYS in advance. Further, in multi-systemVCR, it is more convenient to set the designated channel to several Programme Numbers.MANUAL TUNE