Panasonic TX-23LX60A Operating Instructions Manual

Also see for TX-23LX60A: Service manual

Contents

Panasonic TX-23LX60A Operating Instructions Manual Manual pdf 26 page image

26Technical InformationInput signal that can be displayed∗ Mark: Applicable input signal for Component (Y, P B/CB , PR /CR ) and HDMINote • Signals other than above may not be displayed properly.• The above signals are reformatted for optimal viewing on your display.Stereo / Bilingual Sound SelectionControl with HDMI• Setup the equipment to enable this function. Read the manual of the equipment.• Switch the TV unit on again with the equipment on when connection or setup is changed.• This function may not work normally depending on the equipment condition.• The equipment can be operated by TV’s remote control with this function on even if TV is in Standby mode.• Image or sound may not be available for the first few seconds when the playback starts.• Image or sound may not be available for the first few seconds when Input mode is switched.HDMI connections to some Panasonic equipments allow you to enjoy the easy playback or home theatre.Note• If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switchingoccurs, it is recommended you switch from STEREO to MONO.• Even when the contents of the receiving signal undergo changes, selection mode is kept intact.• When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, usingthe stereo / bilingual sound selection button.• DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.Signal name Horizontal frequency (kHz) Vertical frequency (Hz) Component HDMI480i(525)/60Hz 15.73 59.94 ∗ ∗480p(525)/60Hz 31.47 59.94 ∗ ∗576i(625)/50Hz 15.63 50.00 ∗ ∗576p(625)/50Hz 31.25 50.00 ∗ ∗720p(750)/60Hz 45.00 60.00 ∗ ∗720p(750)/50Hz 37.50 50.00 ∗ ∗1080i(1125)/60Hz 33.75 60.00 ∗ ∗1080i(1125)/50Hz 28.13 50.00 ∗ ∗When you receive the stereo / bilingual sound system, sound output modes can be selected by pressingthe Stereo / Bilingual Sound Selection button.Audio Signal STEREO MAIN I SUB II MONOMode Indicator I IINICAM .......Used in New Zealand, Singapore, Hong Kong etc.Type of broadcast Regular broadcast(Standard Audio)Regular + NICAM MONO I(MAIN I ) NICAM STEREO NICAM DUAL MONO(MAIN I / SUB II )Mode Indicator No Indicator I I IIA2 (German) .......Used in Australia, Malaysia etc.Type of broadcast Regular broadcast(Standard Audio)BILINGUAL or DUAL MONO:MAIN I / SUB II STEREOMode Indicator No Indicator I II