Panasonic TX-21CK1 Operating Instructions Manual

Panasonic TX-21CK1 Operating Instructions Manual Manual pdf 19 page image

19VCR and Satellite Receiver installationYour new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart connection ispreferable if the VCR is so equipped.However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCR onprogramme position ‘0’ of the TV. It will be necessary to either adjust the RF channel of your VCR (some VCR’s allow adjustment of theirRF channel via their remote control unit) or to adjust the tuning of the TV’s programme position ‘0’ or both until it receives the RF outputchannel of your VCR.It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment.Use the AV Scart terminal for a VCR.To tune your TV to the VCRSwitch on the VCR, insert and play apre--recorded tape with known content.Press the F button.Select Setup menuAccess Setup menuSelect Tuning menu.Access Tuning menu.Select Manual tuningAccess Manual tuningSelect programme position “0” VCR.Start searching for the VCR playbackof the known content tape.When the VCR playback is found, pressTV/AV to store.Press the N button to exit.See below for installation ofVCR and Satellite Receiver.Notes :` If picture patterning occurs on programme position ‘0’ itmay be necessary to adjust the RF output channel of theVCR, refer to the VCR instruction book.If a Satellite Receiver and a VCR are going to be used withRF cable connections it is important to avoid both unitsbeing set on the same channel.Refer to the Satellite Receiver and VCR instruction booksfor precise tuning information.VCRCH32VCRSetup Menu4:3NormalAccessColour BalanceTuning MenuAspect21 68Manual TuningSelectAccessExitReturnProgrammeSearchReturn ExitStore