Panasonic TH-85PB1U Operating Instructions Manual

Also see for TH-85PB1U: Operating instructions Operating instructions Brochure & specs

Contents

Panasonic TH-85PB1U Operating Instructions Manual Manual pdf 14 page image

14PC Input Terminals connectionNotes:• With regard to the typical PC input signals that are described in the applicable input signals list (see page 62), adjustmentvalues such as for the standard picture positions and sizes have already been stored in this unit. You can add up to eightPC input signal types that are not included in the list.• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanningfrequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to “4:3”, and 1,920 × 1,080dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possibleto show ne detail with sufcient clarity.• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will needto make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the speciedfrequency range.• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.• Change the “COMPONENT/RGB-IN SELECT” setting in the “SETUP” menu to “COMPONENT”(when COMPONENT signal connection) or “RGB” (when RGB signal connection). (see page 49)Signal Names for Mini D-sub 15P ConnectorPin Layout for PC InputTerminalPin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R (PR /CR ) 6 GND (Ground) 11 NC (not connected)2 G (Y) 7 GND (Ground) 12 SDA3 B (PB/CB ) 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 +5 V DC 14 VD5 GND (Ground) 10 GND (Ground) 15 SCLConnections167839451015 14 13 12 112Connect a cable which matchesthe audio output terminal on the computer.COMPUTERStereo mini plug (M3)Conversion adapter(if necessary)Mini D-sub 15p (Male)(Female)Shared with DVI-D IN.