9EnglishWired LANWhen setting up the Display at a place, whereelectric statistic occurs often, take a sufficient anti-static measure before start using.• When the Display is used at a location, wherestatic electricity occurs often, such as on a carpet,communications of the wired LAN is disconnectedmore often. In that case, remove static electricity andthe noise source that may cause problems with anantistatic mat, and re-connect the wired LAN.• In rare cases, the LAN connection is disabled dueto static electricity or noise. In that case, turn off thepower of the Display and the connected devices onceand then re-turn on the power.The Display may not work properly due to strongradio wave from the broadcast station or the radio.• If there is any facility or equipment, which outputsstrong radio wave, near the installation location, setup the Display at a location sufficiently far from thesource of the radio wave. Or, wrap the LAN cableconnected to the LAN terminal by using a piece ofmetal foil or a metal pipe, of which is grounded atboth ends.DisposalWhen disposing the product, ask your localauthority or dealer about the correct methods ofdisposal.AccessoriesAccessories SupplyCheck that you have the accessories and items shownOperating Instructions(CD-ROM × 1)Remote Control Transmitter× 1● N2QAYA000093DVI-D cable × 1IR cable × 1External IR Receiver × 1Batteries for the RemoteControl Transmitter(AAA/R03/UM4 type × 2)Clamper × 3