English6Safety PrecautionsWARNING■ SetupThis LCD Display is for use only with the followingoptional accessories.Use with any other type of optional accessories maycause instability which could result in the possibilityof injury.(All of the following accessories are manufactured byPanasonic Corporation.)• PedestalTY-ST43PE8• Early Warning SoftwareET-SWA100 series*1• Video Wall ManagerTY-VUK10*2*1: Suffix of the part number may differ depending onthe license type.*2: Supports Ver1.2 or later.Note● The part number of the optional accessories aresubject to change without notice.When installing the pedestal, read the operatinginstructions supplied with it carefully and install properly.Also, always use the overturn prevention accessories.We are not responsible for any product damage, etc.caused by failures in the installation environment forthe pedestal or wall-hanging bracket even during thewarranty period.Small parts can present choking hazard if accidentallyswallowed. Keep small parts away from young children.Discard unneeded small parts and other objects,including packaging materials and plastic bags/sheets toprevent them from being played with by young children,creating the potential risk of suffocation.Do not place the Display on sloped or unstablesurfaces, and ensure that the Display does not hangover the edge of the base.• The Display may fall off or tip over.Install this unit at a location with minimal vibrationand which can support the weight of the unit.• Dropping or falling of the unit may cause injury ormalfunction.Do not place any objects on top of the Display.• If foreign objects or water get inside the Display, ashort-circuit may occur which could result in fire orelectric shock. If any foreign objects get inside theDisplay, please consult your local Panasonic dealer.Transport only in upright position!• Transporting the unit with its display panel facingupright or downward may cause damage to theinternal circuitry.Ventilation should not be impeded by coveringthe ventilation openings with items such asnewspapers, table cloths and curtains.For sufficient ventilation, see page 9.Caution - For use only with UL Listed Wall MountBracket with minimum weight/load 25.0 (55.2 lbs).When installing the Display vertically;When installing the Display vertically, be sure thatthe Power Indicator comes to the downside. Heat isgenerated and it may cause fire or damage to theDisplay.Power indicatorCautions for Wall or Pedestal Installation• Wall or Pedestal installation should be performedby an installation professional. Installing the Displayincorrectly may lead to an accident that results indeath or serious injury. Use the optional Pedestal.(see page 6)• When installing on a wall, a wall hanging bracket thatconforms to VESA standards must be used.55-inch model 49-inch model : VESA 400×40042-inch model : VESA 200×200(see page 9)• Before installation, be sure to check if the mountinglocation has enough strength to support the weightof the LCD display and the wall hanging bracket foranti drop.• If you terminate the use of the Display on the Wall orPedestal, ask a professional to remove the Display assoon as possible.• When mounting the Display on the wall, prevent themounting screws and power cable from contactingmetal objects inside the wall. An electric shock mayoccur if they contact metal objects inside the wall.Do not install the product to a place where theproduct is exposed to direct sunlight.• If the screen is exposed to direct sunlight, the liquidcrystal panel may have adverse effect.■ When using the LCD DisplayThe Display is designed to operate on 110 - 127 or220 - 240 V AC, 50/60 Hz.Do not cover the ventilation holes.• Doing so may cause the Display to overheat, whichcan cause fire or damage to the Display.Do not stick any foreign objects into the Display.• Do not insert any metal or flammable objects into theventilations holes or drop them onto the Display, as