Off timer 90min123PC4:3COMPONENTNANODRIFT13Basic ControlsRemote Control TransmitterStandby (ON / OFF) buttonThe Plasma Display must first beplugged into the wall outlet and turnedon at the power switch (see page 9).Press this button to turn the PlasmaDisplay On, from Standby mode. Pressit again to turn the Plasma Display Offto Standby mode.ACTION buttonPress to make selections.ASPECT buttonPress to adjust the aspect.POS./SIZE buttonPICTURE buttonSound mute On / OffPress this button to mute thesound.Press again to reactivate sound.Sound is also reactivated whenpower is turned off or volume levelis changed.N buttonPOSITION buttonsINPUT buttonPress to select Input signalsequentially. (see page 11)Digital ZoomAUTO SETUP buttonAutomatically adjusts the position/size of the screen.SET UP buttonSOUND buttonVolume AdjustmentPress the Volume Up “+” or Down “–”button to increase or decrease thesound volume level.R button (see page 14)Press the R button to return toprevious menu screen.OFF TIMER buttonThe Plasma Display can be preset to switch tostand-by after a fixed period. The setting changesto 30 minutes, 60 minutes, 90 minutes and 0minutes (off timer cancelled) each time the buttonis pressed.30 min 60 min0 min (Cancel)90 minWhen three minutes remain, “Off timer 3 min”will flash.The off timer is cancelled if a power interruptionoccurs.RECALL buttonPress the “RECALL” button to displaythe current system status.1 Input label2 Aspect modeAudio inputNANODRIFT Saver operating3 Off timerThe off timer indicator isdisplayed only when the offtimer has been set.