SCREENSAVERSTARTFUNCTION SCROLLING BAR ONLYTIME 99:99MODE OFF38Do not display a still picture, especially in 4:3 mode, for any length of time.If the display must remain on, a SCREENSAVER should be used.FUNCTION selection213Select “SCREENSAVER” in “SETUP” menu and press button.Press to select the FUNCTION.Press to select the desired function.SCROLLING BAR ONLYOVERLAY SCROLLING BARNEGATIVE IMAGEWHITE SCREENMODE selectionSTART setting4 When the MODE is set to ON, press to select START.Press to start SCREENSAVER.The menu screen will disappear and the SCREENSAVER will be activated. To stop theSCREENSAVER under ON, press the R button or any buttons on the main unit.Note: When the display is turned off, the SCREENSAVER will be deactivated.Press to select theMODE.Press to select eachmode items.SCREENSAVER (For preventing image retention)OFFINTERVAL : Operates when SHOW DURATION and SAVERDURATION are set up and those times arrive.TIME OF DAY : Operates when START TIME and FINISH TIMEare set up and those times arrive.STANDBY AFTER SCR SAVER : Operates while SCREENSAVER DURATION,and display enters standby mode.ON : Operates when START is selected and theACTION ( ) button is pressed.NEGATIVE IMAGE : A negative image will be displayed on the screen.SCROLLING BAR ONLY : A white bar will scroll from left to right. The image won't be displayed.OVERLAY SCROLLING BAR : The brightness of the image will be decreased and a white barwill scroll on it.WHITE SCREEN : The whole screen will be white.