Panasonic TH-50PB2W Operating Instructions Manual

Also see for TH-50PB2W: Operating instructions Operating instructions Operating instructions Operating instructions

Contents

Panasonic TH-50PB2W Operating Instructions Manual Manual pdf 15 page image

15Basic ControlsMain UnitINPUT MENU ENTER/+/VOL-/MENU Screen ON / OFFEach time the MENU button is pressed, the menuscreen will switch.Normal Viewing PictureSound Pos./Size SetupINPUT button(INPUT signal selection)Volume AdjustmentVolume Up “+” Down “–”When the menu screen isdisplayed:“+” : press to move the cursor up“–” : press to move the cursordownEnter / Aspect buttonRemote control sensorMain Power On / Off SwitchPower IndicatorThe Power Indicator will light.• Power-OFF .... Indicator not illuminated (The unit willstill consume some power as long asthe power cord is still inserted into thewall outlet.)• Standby ........ RedOrange (When “Slot power” is set to“On” and Terminal Board is installed.)Brightness SensorDetects the brightness in the viewing environmentOrange (Depending on the type of the function board installed, when the power is supplied tothe slot)Orange (When “Control I/F Select” is set to “LAN” or “WEB Control” is set to “On”. Refer to“Operating Instructions, Network Operations”)Orange (When “Quick WHITEBOARD Launch” is set to “On”.)Orange (When “Standby pen charging mode” is set to “On” or “On[4hrs]”.)• Power-ON ...... Green• PC Power management (DPMS)........................ Orange (With PC input signal.)When this function is set to ON, it operates under the following conditions to turn the power onor off automatically.When no pictures (HD/VD sync signals) are detected for 60 or so seconds during PC signalinput:→ Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected:→ Power is turned on; the power indicator lights up green.• DVI-D Power management........................Orange (With DVI input signal.)• No Signal power off........................RedEquipment power supply is turned OFF when there is no signal.When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the inputsignals stop.