Panasonic TH-50PB2W Operating Instructions Manual

Also see for TH-50PB2W: Operating instructions Operating instructions Operating instructions Operating instructions

Contents

Panasonic TH-50PB2W Operating Instructions Manual Manual pdf 12 page image

12ConnectionsExample of Network Connection (Wired LAN)Connecting Wireless Module (Wireless LAN)Notes:• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.• To connect a device using 100BASE-TX, use “category 5” LAN cable.• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.Do not touch the LAN terminal or a metal part of the LAN cable.• For instructions on how to connect, consult your network administrator.Display (main unit, rear)Hub or broadband routerLAN cable(not supplied)COMPUTERLess than10 cmLess than10 cmFerrite core(supplied)Ferrite core(supplied)Installing the Ferrite corePull back the tabs(in two places)Wind the cabletwiceOpenPress the cablethrough and closeTo use the wireless function, the wireless module (ET-WM200E) (sold separately) is necessary.When connecting the wireless module to thedisplay, remove the protective film and cap.Connecting procedureHold the wireless module with its LED on the nearside and connect it to the wireless module connectionterminal.Note:Do not connect any other device than the wireless module(ET-WM200E).ET-WM200LEDWhen using the electronic penUsing the electronic pen with the wireless module(ET-WM200E) connected may result in malfunction ofthe electronic pen due to radio wave interference asan example. In that case, set “Wireless Lan” to “Off”before using the electronic pen. (refer to “OperatingInstructions, Network Operations”)