Accessories+-+-Accessories SupplyPower supply cordBatteries for the RemoteControl Transmitter(R6 (UM3) Size × 2)Remote ControlTransmitterN2QAYB000691Operating Instruction bookCheck that you have the accessories and items shownRemote Control BatteriesRequires two R6 batteries.1. Pull and hold the hook, then openthe battery cover.2. Insert batteries - note correctpolarity ( + and -).3. Replace the cover.Helpful Hint:For frequent remote control users, replace old batteries with Alkalinebatteries for longer life.Precaution on battery useIncorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.Disposal of batteries should be in an environment-friendly manner.Observe the following precaution:1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.5. Battery replacement is necessary when remote control acts sporadically or stops operating the Display set.6. Do not burn or breakup batteries.Batteries must not be exposed to excessive heat such as sunshine, re or the like.“R6 (UM3)” sizeCD-ROM(Operatinginstructions)Ferrite core × 2J0KG00000014Cable tie × 2TMM17499Use the Ferrite coresto comply with the EMCstandard.6English