Note● TV Guide may also be used to set timer event.Watching > TV Guide > Timer Programming● Timer Programming can store up to 15 events.● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● For recording using Timer Programming, the TV must be either on or inStandby. For reminders to be displayed, the TV must be on.● No other channels can be selected while recording of Timer Programmingis in progress.● Recording an encrypted (copy-protected) programme may not be possible.● When the start time comes, the channel will be switched automatically andthe video and audio signals will be output. 2 minutes before the start time,a reminder message appears if you are watching TV.– To remove the message and start the programming, press OK.– To cancel the programming, press EXIT.● LED turns to orange in Standby mode when Timer Programming is set.● Reminder messages will remain displayed until one of the followingoccurs:– You press OK to view the programme or EXIT to cancel the reminder.– The timer event that the reminder is set for ends.● “!” identifies that two or more timer events are overlapped. USB HDD Rec.is given priority over Reminder. As for the overlapped recording events,the first event starts and finishes as programmed. The next event can thenstart.● The recording of Timer Programming automatically changes the channel tothe programmed channel a few seconds before the start time.● The recording of Timer Programming is performed even if the TV isin REW LIVE TV recording. In this case, REW LIVE TV recording iscancelled.Recording > Recording current programme > REW LIVE TV● For details of the USB HDDRecording > Technical information- 92 -
