Panasonic TH-42PX60X Operating Instructions Manual

Also see for TH-37PX60U: Technical guide Operating instructions Operating instructions Service manual Operating instructions

Contents

Panasonic TH-42PX60X Operating Instructions Manual Manual pdf 15 page image

28 29AdvancedEditing and Setting ChannelsApplyCaption detail---Caption selectPresetAuto programANT InModeStart scanAllCableEdit- - -FavoriteApplyNoAddEditCH12345- - -2- - -- - -- - -FavoriteApply- - -- - -- - -- - -CaptionNoYesNoNoNoAddSignal meterCHSignal strengthCurrentPeak level85 %85 %2 - 1Apply12FavoriteFavorite-MenuPictureAudioLockSetupMemory cardTimerSetupCH scanLanguageClockProgram channelInput labelsCCAllProgram channelAutoManualSignal meterAuto programANT InModeStart scanAllCableCheck the signal strength if interference is found or freezing occurs on a digital image.Select the station identifierSelect All or AnalogAll: Analog and digitalAnalog: Analog onlySettings are madeautomatically• After completing the setting,select “Apply”. (see below ).• All previous memorizedchannels are erased.setselectSelect “ANT In”Select “Mode”Select “Start scan”Select “Edit”Select the item to be editedselect item to edit(Caption/Favorite/Add)nextEdit• Caption:Changes the station identifier• Favorite:Registers channel to Favorites List• Add:Adds or deletes channelsstartselect(Select Cable or Antenna)selectnextCaptionFavoriteAdd•CaptionPresetCaption detailRename (maximum 7 characters available)Select the number•FavoriteFavorite•Add• Press “OK” button to select “Yes (add)” or “No(delete)”Select “Apply”Press to move cursor to“Apply”Signal intensityselect channelokEditing and Setting ChannelsSelect “Setup”2Display menu134ŶPress to exitThe current channel settings can be changed according to your needs and reception conditions.ŶTo reset the settings of Setup menuSelect “Reset” in Setup menu ( ) and press “OK”buttonInput your 4-digit password with number buttonsSelect “Yes” on the confirmation screen and press“OK” buttonSet5Select “Program channel”Select the functionChecksignalstrengthSignalmeterSetautomaticallyAutoSetmanuallyManualUse this procedure when changing setting of receiving channels or changing the channel display.Also, use to add or delete channels from channel list manually.Automatically searches and adds receivable channels to memory.nextselectnextselectnextselectselectset/nextok(to enteryourprogram)selectnext• If the signal is weak, check the antenna.If no problem is found, consult yourlocal dealer.Note• Not available if “Cable” is selected in “ANT In”(see above).• Effective only for digital antenna channels.• If “Channel lock” (p. 26) is activated and “Auto”, “Manual” or “Signal meter” is selected, “Enter password.” will bedisplayed.