Panasonic TH-42PM50U Operating Instructions Manual

Also see for TH-42PM50U: Service manual Service manual

Panasonic TH-42PM50U Operating Instructions Manual Manual pdf 7 page image

7Cables that are not included in the package will need to be obtained separately.The Video/Audio connection between components can be made with shielded video and audio cables. For bestperformance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer orelectronic supply store.Before you purchase any cables, be sure you know what type of output and input connectors your various componentsrequire. Also determine the length of cable you will need.LocationThis unit is intended to be used with the stand or bracket. Consult your dealer for available options. Position forcomfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen.Use of some types of fluorescent lighting can reduce remote control transmitter range.Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat ormoisture.Optional External EquipmentRemote Control Battery InstallationPrecaution on battery useIncorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.Disposal of batteries should be in an environment-friendly manner.Observe the following precautions:1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.Two AA size1.Turn the transmitter face down.Press and slide off the batterycover.2.Install the batteries as shown inthe battery compartment.(Polarity + or – must match themarkings in the compartment.)InstallationRequires two AA batteries.3.Replace the cover and slide inreverse until the lock snaps.Helpful Hints:For frequent remote control users, replace old batteries with Alkaline batteries for longer life.