Panasonic TH-42PF50U Operating Instructions Manual

Also see for TH-42PF50U: Operating instructions Operating instructions Manual Del Usuario

Contents

Panasonic TH-42PF50U Operating Instructions Manual Manual pdf 15 page image

INPUT MENU ENTER/+/VOL-/15MENU Screen ON / OFFEach time the MENU button is pressed, the menu screenwill switch.INPUT button (Input signal selection)Basic ControlsMain Power On / Off SwitchPower IndicatorThe Power Indicator will light.• Power-OFF .... Indicator not illuminated (The unit willstill consume some power as long as thepower cord is still inserted into the walloutlet.)• Standby ........ RedVolume AdjustmentVolume Up “+” Down “–”When the menu screen isdisplayed:“+” : press to move the cursor up“–” : press to move the cursor downEnter / Aspect buttonNormal Viewing PICTURE SETUPSOUND POS./SIZERemote control sensorBrightness SensorDetects the brightness in the viewing environmentMain UnitOrange (When “Slot power” is set to “On”.)Orange (Depending on the type of the function board installed, when the power is supplied to theslot)Orange (When “CONTROL I/F SELECT” is set to “LAN” or “WEB CONTROL” is set to “ON”.Refer to “Operating Instructions, Network Operations”.)• Power-ON ...... Green• PC POWER MANAGEMENT (DPMS)........................ Orange (With PC input signal.)When this function is set to ON, it operates under the following conditions to turn the power on oroff automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected:Power is turned on; the power indicator lights up green.• DVI-D POWER MANAGEMENT........................Orange (With DVI input signal.)• NO SIGNAL POWER OFF........................RedEquipment power supply is turned OFF when there is no signal.When this is set to “ENABLE”, the power supply of the unit goes Off 10 minutes after the inputsignals stop.