Panasonic TH-42PF30U Service Manual

Also see for TH-42PF30U: Operating instructions Operating instructions

Panasonic TH-42PF30U Service Manual Manual pdf 34 page image

34TH-42PF30U9.2. Adjustment9.2.1. RGB white balance adjustmentInstrument Name Connect to Setting• RGB VGA60 W / B pattern• Color analyzer(Minolta CA-100 or equivalent)PC IN terminalPanel surfacePicture menu: STANDARDUser setting: Normalexcept PICTURE: max 30Steps Remarks[Conditions]• Make sure the front panel to be used on the final set is fitted.• Make sure a color signal is not being shown before adjustment.• Put the color analyzer where there is little color variation.[Adjustment]1. Set COMPONET / RGB-IN SELECT to RGB.2. Select the IIC mode “PANEL W / B Adj.” item.3. Check that the color temperature is “COOL (Hi)”.4. Output a white balance pattern.5. Touch the signal receiver of color analyzer to the highlight window’s center.6. Fix G drive at E0h and adjust B drive and R drive so x, y become the "Color temperatureCOOL(Hi)" in the below table. Adjust it again after it lowers of 08h data when the adjust-ment is NG. ( In addition, adjust it after it lowers by 08h data for NG. )7. Adjust R/G/B together by multiplication so the maximum drive value in R/G/B becomesFCh with the gain ratio kept. (ALL-DRIVE)8. Set color temperature to “NORMAL (Mid)”.9. Fix G drive at E0h and adjust B drive and R drive so the highlight window's x, y becomesthe "Color temperature NORMAL(Mid)" in the below table.Adjust it again after it lowers of 08h data when the adjustment is NG.( In addition, adjust it after it lowers by 08h data for NG. )10. Adjust R/G/B together by multiplication so the maximum drive value in R/G/B becomesFCh with the gain ratio kept. (ALL-DRIVE)11. Set color temperature to “WARM (Low)”.12. Set G drive to E0h and adjust B drive and R drive so the highlight window's x, y becomethe "Color temperature WARM(Low)" shown in the below table.Adjust it again after it lowers of 08h data when the adjustment is NG.(In addition, adjust it after it lowers by 08h data for NG.)13. Adjust R/G/B together by multiplication so the maximum drive value in R/G/B becomesFCh with the gain ratio kept. (ALL-DRIVE)14. Copy the R drive, G drive and B drive data in NTSC, PAL DVI region.Adjustment targetHi-light: x ± 0.003 y ± 0.003Hi-light is target of the number at drive adjustment in the hi-light windows.Therefore, it is not target of the hi-light number at after adjustment white balance.Picture menu: STANDARDUser setting: Normalexcept PICTURE: max 30Aspect: Full (16 : 9)Position and size: Normal• “7” key : color temperature select.• “9” key : Picture menu select.• Highlight section Signal amplitude 75%• Drive standard G: E0h