Panasonic TH-42PF20W Operating Instructions Manual

Also see for TH-42PF20E: Operating instructions Operating instructions

Contents

Panasonic TH-42PF20W Operating Instructions Manual Manual pdf 24 page image

00NormalNormaliseAuto SetupPos. /SizeV-Pos0H-PosV-SizeDot ClockH-SizeClock PhaseClamp Position1:1 Pixel Mode Off000024Adjusting Pos. /Size1 Press to display the Pos. /Size menu.Press to select the menu to adjust.Press to adjust the menu.Press to exit from adjust mode.32Notes:• Adjustment details are memorized separately for different input signal formats (Adjustments for component signals arememorized for 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF,1250 (1080) / 50i, 750 (720) / 60p · 50p each, and RGB/PC/Digital signals are memorized for each frequency.)• If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This pictureposition movement cannot be controlled by the Picture Pos./Size function.Note:Unadjustable items are grayedout.Adjustable items differ dependingon the input signal and thedisplay mode.4Auto Setup H-Pos/V-Pos, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted when the RGB orPC signal is received.This setting is enabled under the following conditions:• This setting only support single screen display. Two screen display or multiple display are notsupported.• When “Component/RGB-in Select” or “YUV/RGB-in select” in the “Setup” menu (see page 47) is set to “RGB”,this setting is enabled.• When the signal is not PC format, this setting is enabled only if “Over scan” (see page 25) is “Off” or“1:1 Pixel Mode” (see page 26) is “On”, and H-Size/V-Size is not automatically adjusted.This setting will be invalid and will not work under the following conditions:• Aspect is set to “Just”• “Display size” in the Options menu (see page 54) is set to “On”Using Remote ControlWhen on the remote control is pressed, “Auto Setup” will be executed.When Auto Setup does not work, “Invalid” is displayed.Auto modeWhen the “Auto Setup“ is set to “Auto” in the Options menu (see page 55), automatic position adjustment starts:• When the display power is turned ON.• When the input signal is switched.