b. Release all cables from the clamper on the bracket of thefront frame.c. For leaving the plasma panel from the front frame, pull thebottom of the front frame to forward, lift, and remove.7.17. Removal of stand bracketsa. Remove the plasma panel section from the servicing standand lay on a table (covered), with the plasma panel surfacefacing downward.Spread a soft cloth for protection, to prevent panel surface fromscratching.b. Remove the stand bracket (left, right) fastening screws (×4each) and remove the stand brackets (left, right).7.18. Replacement of the plasmapanela. Place the new plasma panel (finished) on the flat surface ofthe table (covered by a soft cloth), with the plasma panelsurface facing downward.b. Fit the stand brackets (left, right.) fast 4 screws each on thenew plasma panel.c. Place the plasma panel section on the servicing stand.d. Attach the front frame each P.C.Board and so on, to the newplasma panel.* When fitting the front frame, be careful not to allow anydebris, dust or handling residues to remain between thefront glass and plasma panel.15TH-37PW7BX