Panasonic TC-P60GT50 Service Manual

Also see for Viera TC-P60GT50: Ehelp Owner's manual

Panasonic TC-P60GT50 Service Manual Manual pdf 17 page image

178 Service Fixture & Tools8.1. SC jigPurpose:To find the failure board (SC or SU/SD) when the power LED is blinking 7 times.SC jig:Jumper connector to connect to SC50 connector on SC boardPart number:TZSC09187How to use:Caution: Remove SC jig from SC board after inspection.1. Remove all connector between SC board and SU/SD board to isolate SC board from both SU and SD board electrically.Note: The board will be damaged if all connector is not removed (for example; remove connector only for SU board and stayconnecting with SD board. The board will be damaged.)2. Connect SC jig to connector SC50 at left bottom side of SC board3. Turn on the TV/Display Unit and confirm the power LED blinking.LED blinking: Possible cause of failure is in SC boardNo LED blinking (Lighting or no lighting): Possible cause of failure is in SU or SD board4. After inspection, turn off the TV/Display Unit and wait a few minutes to discharge.5. Remove SC jig from SC board.Remark: This SC jig can be used for all 2012 Plasma TV and Plasma Display.