Slide 57• When the 2013 Plasma TV fail with a shutdown condition making the power LED blink, it turnson automatically when it’s disconnected and plugged in again regardless of the time it hasbeen unplugged. Therefore, expect the power LED to blink as it was before the TV wasunplugged when power is applied to the TV.• To avoid the unnecessary replacement of multiple PC boards, please read this beforebeginning to repair this unit.• Do not use any service documentation (Including the 2011 troubleshooting guide) other thanthe one designed for this particular model.• Techniques used on previous models may not necessarily apply to the model you areworking on.• For accurate diagnosis during troubleshooting, do not skip or alter the order of steps on theguide.• When the 2013 Plasma TV fail with a shutdown condition making the power LED blink, it turnson automatically when it’s disconnected and plugged in again regardless of the time it hasbeen unplugged. Therefore, expect the power LED to blink as it was before the TV wasunplugged when power is applied to the TV.• To avoid the unnecessary replacement of multiple PC boards, please read this beforebeginning to repair this unit.• Do not use any service documentation (Including the 2011 troubleshooting guide) other thanthe one designed for this particular model.• Techniques used on previous models may not necessarily apply to the model you areworking on.• For accurate diagnosis during troubleshooting, do not skip or alter the order of steps on theguide.Important InformationSOS Detect Circuit Explanation