Panasonic TC-L32XM6 Service Manual

Also see for Viera TCL32XM6: Owner's manual Instrucciones de operación

Contents

Panasonic TC-L32XM6 Service Manual Manual pdf 28 page image

288. Trouble shooting1. Fault clearanceBefore calling your dealer or service center for assistance, check the matters below once again.(1) Make sure you have connected LED TV to your equipment as described in the section“ CONNECTING LED TV”.(2) Check cable connection. Verify that all external equipment and power cord are properlyconnected.(3) Verify that all power is switched on.(4) If LED TV still does not produce an image, re-start the external equipment.(5) If the image still does not appear, unplug LED TV from the external equipment and check theexternal equipment. The problem may be with your graphics controller rather than with LED TV.(When you reconnect LED TV, remember to turn the external equipment and TV off before youpower up LED TV. Power the equipment back on in order of LED TV and external equipment.)(6) If the problem still exists, check the following chart.Problem Try these SolutionsNO POWER Plug this LED TV into the AC outlet. Press POWER button on side control or on Remote Control to turn on LED TV. Check POWER Indicator. If this indicator blank, this TV has getting trouble.RemoteControl doesnot work Check the batteries. Make sure nothing is between the Remote Receiver and the Remote Control. Make sure you are not too far from LED TV when using Remote Control. Maximum operating range is 5m. Is direct sunlight or strong artificial light shining on LED TV‘s Infrared RemoteReceiver? Eliminate the light by closing curtains, pointing the light in a differentdirection, etc.No image Check the connection between the external equipment and LED TV. When turning LED TV on, it takes within 7 seconds (ATV mode) to display theimage. Check the system that you select is corresponding with the external equipmentor the video equipment. Make sure the temperature is not out of the Operating Temperature (0°C ~40°C). Turn off power, then turn on again, re-start LED TV.No sound Check Audio cable connection from Audio input source. Adjust the Sound System. Press VOLUME (+) button. Press MUTE button.There are tinyblack pointsand/or brightpoint on the TV Dark or bright points of light (red, green, or blue) may appear on the screen.This is a characteristic of the LED panel, not a malfunction of the LED TV. LED panel is produced with very high accuracy technology. There is 99.99% ormore dot pixel, but there is also 0.01 % or less of dot pixel lack or dot pixel thatis constantly lighted. This is not defect. Regarding LED panel characteristic, it may occur picture remain (look like amirror) when the screen is changed if it displays same screen for a long time.Changing the picture or turn-off the power supply may recover. Stripe pattern (more, interference stripes) may show up on the screen dependson the reflected picture.Abnormalcolor of image Adjust the value of color. Select different color system.