Panasonic TC-L32X30 Owner's Manual

Also see for VIERA TC-L32X30: Service hints Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Panasonic TC-L32X30 Owner's Manual Manual pdf 40 page image

40Network settingsThis is a setting for connecting to a broadband environment.ŶPress to exit froma menu screenŶPress to go back tothe previous screenDisplay the menuSelect “Network settings”Menu Setup 1/2ANT/Cable setupInput labelsNetwork settingsVIERA Link settingsECO/energy savingChannel surf modeLanguageClockAllselectSelect the settings and set selectadjustMenu Network settingsNetwork cameras listSoftware updateMac addressConnection testNetwork connectionWireless networkIP address/DNS settingsWireless (WiFi)00-0b-97-7c-65-e9Connection testCheck that the Network settings are as shown below, and then start “Connection test”.Select “Connection test” and press OK(It takes a while to cancel the test.)Displayed Connection test screenConnection testCheck Ethernet cable connectionValidate IP addressCheck for IP address duplicationCheck connection to the InternetCheck communication with EASY IPTV server.Test in progress...Complete Connection testSuccess-->Completion screen is displayed.Error-->Follow the directions on screen to complete the setting.If you perform the Proxy settings, check the Proxy addressand the Proxy port number.Network connectionSelect Network type (Ethernet cable/Wireless (WiFi))Wireless network (Confirm Current settings and status)This setting is performed only when “Wireless (WiFi)” is selected in “Network connection” above.ŶDisplayed “Current settings and status” screen (If connected with wireless LAN adapter)You can confirm the AP connection status.(SSID/Wireless type/Security type/Encryption type/Connection status /Signal strength)Press “Wireless network”(example)selectOKWireless networkSSID :Wireless type :Security type:Encryption type :Connection status :Signal strength :Connect using these settings?Yes NoWhen you change “Wireless network” -->Press “No”See “Sets / Changes wireless network setting” on p. 41and follow the directions on screen to complete thesetting.You need to be “Connected” to use network devices.Please set Access point settings to “Connected”.