8OUTPUT INPUTUse this configuration when connecting the TV to a cable TV system using a Cable Box.Connect the cable from the Outputterminal on the back of the CableBox to the ANT terminal on the leftside of the TV.CABLE BOXTERMINAL ON THE BACKOF THE CABLE BOXIncoming Cable fromAntenna or Cable TVSystemIncoming Cable From Home Antenna (75 Ohm) / Incoming 75 Ohm Cable (From Cable Company)Cable Connection - For reception of cable channels (01 - 125) connect thecable supplied by your local cable company. Antenna Mode must be set toCABLE. (Refer to Antenna Mode section.)Note:Certain cable systems offset some channels to reduce interference or havePremium (scrambled) channels. A cable converter box is required for properreception. Check with your local Cable company for its compatibility requirements.Connecting the Antenna Cable to the RF In TerminalUHF AntennaVHF AntennaMixer75 Ohm Coaxial CableRF in TerminalCoaxialAntenna PlugClamperAntenna Connection - For proper reception of VHF/UHF channels, an external antenna is required. Forbest reception an outdoor antenna is recommended.Antenna Mode must be set to TV.InstallationAntenna / Cable ConnectionANTENNATERMINAL ONTHE LEFT SIDEOF THE TVAntenna Connection (Cable Box, no VCR)VHF/UHFUsing the Cable Cover4. Installing the Cable Cover3. Connect the antenna cable to RF in terminal.2. Using the Cable ClampInsert the 2 upper claws into themating slots.Press in the bottom section of thecover.Removing the Cable CoverRelease the 2 lower claws from theirslots.Slowly pull the cover downward.Claw1. Installing the cable clamp.CoaxialcableOpen the cable clampand pass the antennacable through.