7InstallationCautionKeep batteries out of children’s reach. If batteries are swallowed, contact a physician immediately.Precaution on battery useIncorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.Observe the following precautions:1. Always use new batteries when replacing the old set.2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.3. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.12Remote control battery installationRequires a CR2025 battery1. Draw out the battery tray by slidinglatch 1 and pulling in the directionof 2 as shown below.2. Remove battery as shown below.Install the battery in the battery tray.(Confirm that the positive polemarked “ + ” is facing up.)3. Replace the tray and slide back thelatch until it snaps in place.Notes:• Do not drop, apply shock to or step on the remote control.• Do not spill water on the remote control.• Do not place objects between the remote control and remote control receiver.• Do not use remote controls for other equipment at the same time.• If the TV does not operate even when operating the remote control from a close range, it is time to replace thebatteries (product number: CR2025).Refer to the label on back of the remote control for directions on replacing batteries.Remove the insulation sheet.The lithium battery is included in theremote control at the time of delivery.Remove the insulation sheet tooperate the remove control.“Replacing batteries” label• Be sure to use the power cord and AC adaptor (model no. : N0JZHK000003) included in the accessories.• Usage of AC adapters other than specified may cause malfunctions.AC Adaptor installationBack of the Remote Controlthe insulation sheetReplacing batteriesReplace batteries by following the steps below: