Panasonic TC-14B3R Operating Instructions Manual

Also see for TC-14B3R: Instruction Service manual

Contents

Panasonic TC-14B3R Operating Instructions Manual Manual pdf 12 page image

11VCR AND SATELLITE RECEIVER INSTALLATIONYour new TV is supplied with programme position ‘0’set to receive an RF signal from a VCR.However, if for some reason the VCR is tuned to a different RF channel then you will not receive any picture or sound from the VCR onprogramme position ‘0’of the TV. It will be necessary to either adjust the RF channel of the VCR or to adjust the tuning of the TV’sprogramme position ‘0’or both until the RF output channel of the VCR is received.It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment.rear ofVCR- + To start search for VCR playbackTo return toviewing screenTo store position? ? To select programme position ‘0’(VCR)Programme position is displayed top leftof screenAccess the Manual tuning menu asdetailed on page 9.TO TUNE YOUR TV TO THE VCRInsertrecorded tapeand selectplaybackSet TV toprogrammeposition ‘0’VCRAdjusttuningOperationcompletedSee below forinstallation of VCRandSatellite ReceiverTO TUNE YOUR VCR TO THE TVRF CHANNEL ADJUSTNote :Some VCR’s are capable of adjusting theirRF channel via their remote control unit.TV/AVManual Tuning: Programme Position- /+ : Start SearchTV/AV : Store.F : Previous MenuN : Exit21 69NVCRTV/AVNIf you are going to use a Satellite Receiver and a VCR, it is important, to avoid tuning problems, that they are both tuned to output theirsignals on different channels. For example, if your VCR is tuned to output channel 32, your Satellite Receiver could be set to outputchannel 34. Refer to your Satellite Receiver and VCR instruction books for precise tuning information.