6 RQT8542Listening to the radio (FM TUNER ONLY)Receiving an FM broadcast clearlySet to “CITY” if reception is poor or if there is interference fromanother station.Each time you press and holdCITY/NORNo display(canceled)CITYSet to “MONO” when there is noise during FM reception.Sound becomes monaural, but noise is reduced.Each time you pressSelecting stereo or monaural FMFM MONO/STNo display(stereo)MONOSound qualityEach time you pressThe effect may differ with different kinds of music.EQS-XBSBoosts thebassNo display(canceled)EnhancedS-XBSTo obtain good receptionThe headphone/earphone cord is also the FM antenna so extend itinstead of leaving it coiled.When connecting the unit to other equipment, set the volumelevel between 10 to 15, then use the volume control on the otherequipment to adjust the volume.Turn off this unit and the other equipment before connection.Insert each plug fully. [Plug type: 3.5 mm (1/8 in.) stereo]To CD or AUXterminalsAudio systemand so onAudio cable (not included)You cannot use an optical cable.Connecting to other equipmentMain unitErasing a memorized station: Perform step for “Storing stations in memory” (above) .Press to select the memorized station to be erased.Press and hold to change rapidly. Do each of the following steps within 10 seconds. Press.The frequency number flashes. Press and holduntil “- - - -” flashes. Press.1 FMM- -.- -MEMOMEMOMEMO(backward) (forward) HOLD VOL CITY/NORFM MONO/STRADIO MEMOEQTUNE MODE RADIOOPR OFF107.10FM1 107.10FMMPress to turn on the radio.Press [OPR OFF] to turn off the radio.Press to adjust the volume. (0 to 25)(VOL: Decrease VOL: Increase)Slide to cancelHOLD.cancel Press to select the station.(: Backward : Forward)Press and hold to scan thestations rapidly.“TUNED ” appears when tuned.When “ M” is displayed, press[TUNE MODE] to cancel it.Information on Disposal in other Countries outside theEuropean UnionThis symbol is only valid in the European Union.If you wish to discard this product, please contact your localauthorities or dealer and ask for the correct method of disposal.-If you see this symbol-Change the frequency step according to the area. Press and holduntil the step appears. Do each of the following steps within 10 seconds. Each time you presseither to select Press and hold until the frequency appearsto confirm the step.FMU0.2When using overseasU0.2 U0.1 EFM 0.2 MHz(original setting)FM 0.1 MHz FM 0.05 MHzMEMORADIO(backward) (forward)Returning to the previous frequency step:Repeat the above procedure.Changing the step erases the stations you stored in memory.Side of the main unitStoring stations in memory Press to display “M”. Do each of the following steps within 10 seconds. Press.Press to select thefrequency.Press and hold to scan thestations rapidly. Press.Press to select the memorynumber.Press and hold to changerapidly. Press to store the station. Repeat steps to to program up to 20 stations.MEMO1 107.10FMM1 98.00FMM1 107.10FMMTUNE MODEMEMO(backward) (forward)MEMO(backward) (forward)Storing stations in memory/Listening to a memorized stationListening to a memorized station Perform step for “Storing stations in memory” (above) .Press to select the memorized station.Press and hold to change rapidly.“TUNED” appears when tuned. Press to adjust the volume.(backward) (forward)(decrease) VOL (increase)