Simple setupRQT638710AC IN1312Adhesive tapeFM indoor antennaFix the other end of the antennawhere reception is best. AM loop antennaStand the antenna up on its base.Keep loose antenna cord away from other wires and cords.To householdmains socketAC mains lead (included)Insertion of connectorEven when the connector is perfectlyinserted, depending on the type of inletused, the front part of the connectormay jut out as shown in the drawing.However there is no problem using the unit.Conserving powerThe unit consumes power (approx. 0.7 W) even when it is turned offwith [Í]. To save power when the unit is not to be used for a long time,unplug it from the household mains socket. Remember to reset the ra-dio stations and any other memory items before using the unit again.For your referenceInformation you enter into the unit’s memory remains intact for up toa week after the AC mains lead is disconnected.[For\the\United\Kingdom\only]BE SURE TO READ THE CAUTION FOR THE AC MAINSLEAD ON PAGE 4 BEFORE CONNECTION.Television and flat cable [DT300] ]DT100]STEP 3Connect directly to your television.Do not connect the unit through a video cassette recorder, because the picture may not be played correctly due to the copy guard.Antennas and AC mains lead [DT300] ]DT100]STEP 4S-VIDEO OUT terminalThe S-video terminal achieves a more vivid picture than the VIDEOOUT terminal by separating the chrominance (C) and luminance(Y)signals. (Actual results depend on the television.)Appliance inletConnectorApprox. 6 mm[For\the\United\Kingdom,\Continental\Eupope\and\Russia]Use the RCAJ adaptor (included) if your televisionhas a 21-pin SCART terminal. You do not have toconnect anything to the AUDIO terminals.VIDEOOUTVideo terminalVideo cable(included) To yourtelevisionAudio terminalsRCAJ adaptorVIDEOOUTS-VIDEOOUT112VIDEOINTo connectcableTo unplugcableNoise filter≥Leave the noise filter attached.Simple setupVideocable(included)