2VQT2W18Getting started-If you see this symbol-CAUTION!THIS PRODUCT UTILIZES A LASER.USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCEOF PROCEDURES OTHER THAN THOSE SPECIFIED HEREINMAY RESULT IN HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.REFER SERVICING TO QUALIFIED PERSONNEL.WARNING:TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR PRODUCT DAMAGE,≥ DO NOT EXPOSE THIS APPARATUS TO RAIN,MOISTURE, DRIPPING OR SPLASHING ANDTHAT NO OBJECTS FILLED WITH LIQUIDS,SUCH AS VASES, SHALL BE PLACED ON THEAPPARATUS.≥ USE ONLY THE RECOMMENDEDACCESSORIES.≥ DO NOT REMOVE THE COVER (OR BACK);THERE ARE NO USER SERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.FCC Note:This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipmentgenerates, uses, and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may causeharmful interference to radio communications.However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:≥ Reorient or relocate the receiving antenna.≥ Increase the separation between the equipment and receiver.≥ Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.≥ Consult the dealer or an experienced radio/TV technician for help.FCC Caution:To assure continued compliance, follow the attachedinstallation instructions and use only shielded interface cables whenconnecting to peripheral devices. Any changes or modifications notexpressly approved by the party responsible for compliance could voidthe user’s authority to operate this equipment.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) this device must accept any interference received, includinginterference that may cause undesired operation.Responsible Party:Panasonic Corporation of North AmericaOne Panasonic WaySecaucus, NJ 07094Support Contact:Panasonic Consumer Electronics CompanyTelephone No.: 1-800-211-PANA (7262)Information on Disposal in other Countries outside theEuropean UnionThis symbol is only valid in the EuropeanUnion.If you wish to discard this product, pleasecontact your local authorities or dealer andask for the correct method of disposal.User memo:DATE OF PURCHASE _________________________DEALER NAME ______________________________DEALER ADDRESS _______________________________________________________________________TELEPHONE NUMBER ________________________The model number and serial number of this product can befound on either the back or the bottom of the unit.Please note them in the space provided below and keep forfuture reference.MODEL NUMBER _____________________________SERIAL NUMBER _____________________________