Panasonic SC-AK330 Operating Instructions Manual

Also see for SA-AK230: Operating instructions Service manual Service manual Service manual

Contents

Panasonic SC-AK330 Operating Instructions Manual Manual pdf 10 page image

RQT7796101 Press [TUNER, BAND] to select band.The unit comes on.Every time you press the button:FM AM2 Press [PLAY MODE] on the remote control to select“MANUAL”.Every time you press the button:MANUAL PRESET3 Hold down [g/REW/3] or [f/FF/4] for a momentto search for a station.The frequency stops when it finds a clear station.To stop during the process, press [g/REW/3] or [f/FF/4].Under excessive interference, a station may not be found.Press [g/REW/3] or [f/FF/4] repeatedly to tune step-by-step.“TUNED” is displayed when a radio station is tuned.“ST” is displayed when a stereo FM broadcast is being received.If noise is excessive in FMRemote control onlyHold down [PLAY MODE] to display “MONO”.Monaural sound is selected and noise reduces when reception is weak.Hold down [PLAY MODE] again to cancel the mode.“MONO” is also cancelled if the frequency is changed.Preparation:Press [TUNER, BAND] to select “FM” or “AM”.Automatic presettingDo the following once each for FM and AM.Preparation: Tune to the frequency where pre-setting is to begin.Hold down [PROGRAM] until the frequency changes.AK330AK230The tuner presets all the stations it can receive into the channels inascending order. When finished, the last station memorized is tuned in.Manual presettingPre-set the stations one at a time.1 Press [PROGRAM] then press [g, REW/3 ] or[f, 4/FF] to tune to the desired station.2 Press [PROGRAM] then press [g, REW/3 ] or[f, 4/FF] to select a channel.3 Press [PROGRAM].The station occupying a channel is erased if another station is presetin that channel.Selecting channelsPress the numbered buttons to select the channel.To enter a 2-digit channel, press [X10], then the two digits.AK330 AK230OR1 Press [PLAY MODE] to select “PRESET”.2 Press [g, REW/3] or [f, 4/FF] to select thechannel.Remote control onlyThere are two methods of pre-setting stations.Automatic presetting : All the stations the tuner can receive arepreset.Manual presetting : You can select the stations to preset and theorder they are preset in.Up to 15 stations each can be set in the FM and AM bands.Manual tuningPreset tuningRadioFor EuropeRDS broadcastingRemote control onlyThis unit can display the text data transmitted by the radio data system(RDS) available in some areas.If the station you are listening to is transmitting RDS signals, “RDS”will light up on the display.Press [CD/RDS DISP].Every time you press the button:Program type (PTY) Frequency display Station name (PS)❈ “M-O-R- M”=“Middle of the road music”For South AfricaAM allocation settingMain unit onlyBy adjusting the allocation, you can enable this tuner to receive AMbroadcasts allocated in 10 kHz steps.Press and hold [TUNER, BAND]. After a few seconds, the display willchange to a flashing display of the current minimum AM frequency. Ifyou continue to hold the button down, the minimum frequency willchange. Release the button at this time.To return to the original frequency indication, repeat above.Note• RDS displays may not be available if reception is poor.• After changing the “allocation” setting, the frequencies you previouslypreset in the memory will be cleared.• Sound is momentarily interrupted if you load/unload tapes whilelistening to an AM broadcast.COUNTRYNATIONALOLDIESFOLK MDOCUMENTTESTALARMFINANCECHILDRENSOCIAL ARELIGIONPHONE INTRAVELLEISUREJAZZNEWSAFFAIRSINFOSPORTEDUCATEDRAMACULTURESCIENCEVARIEDPOP MROCK MM-O-R- M❈LIGHT MCLASSICSOTHER MWEATHERProgram type displaysCD/RDS DISPPROGRAMDISCRadio