Panasonic SABTT268 Owner's Manual

Reference39VQT3M40MessagesThe following messages or service numbers appear on thetelevision or unit’s display when something unusual is detectedduring startup and use.Cannot play.≥ You inserted an incompatible disc. (Discs recorded in PALvideo, etc.)Cannot display on this unit.≥ You tried to play a non-compatible image.No disc is inserted.≥ The disc may be upside down.$ This operation is not available.≥ Some operations are unsupported by the unit. For example;jBD-Video: During playback, reverse slow-motion orreverse frame-by-frame is not possible.IP address is not set.≥ The “IP Address” in “IP Address / DNS Settings” is “---. ---.---. ---”. Set the “IP Address”, “Subnet Mask”, and “DefaultGateway”. (Select the automatic address acquisition ifnecessary.)No Video≥ Depending on the connected iPod/iPhone, video menu maynot be available on the TV. Select “ALL” on the unit’s displayand operate video playback from your iPod/iPhone menu.(> 29)F99≥ The unit fails to operate properly. Press [POWER Í/I] on themain unit to switch the unit to standby for 3 seconds. Nowpress [POWER Í/I] on the main unit again to turn the uniton.U59≥ The unit is hot.The unit switches to standby for safety reasons. Wait forabout 30 minutes until the message disappears.Select a position with good ventilation when installing theunit. Do not block the ventilation hole on the rear and side ofthe unit.HDMI ONLY≥ Some BD-Video discs can only be output with HDMI.NET≥ While connecting to a network.No PLAY≥ There is a viewing restriction on a BD-Video or DVD-Video.(> 31)No READ≥ The media is dirty or badly scratched. The unit cannot play.PLEASE WAIT≥ The unit is carrying out an internal process.This is not amalfunction. You cannot operate the unit while “PLEASEWAIT” is displayed.SET (“ ” stands for a number.)≥ The remote control and main unit are using different codes.Change the code on the remote control.Press and hold [OK] and the indicatednumber button at the same time formore than 5 seconds.H or F(“ ” stands for a number.)≥ Check and correct the speaker cable connections.≥ There is something unusual.≥ Check the unit using the troubleshooting guide. If the servicenumber does not disappear, do the following.1 Disconnect the plug from the household AC outlet, wait afew seconds, then reconnect it.2 Press [POWER Í/I] to turn the power on.If the service number does not disappear despite doing theabove, request service from the dealer. Inform the dealer ofthe service number when requesting service.UPD/(“ ” stands for a number.)≥ The firmware is being updated. Please do not turn off power.IPOD OVER CURRENT ERROR≥ The iPod/iPhone is drawing too much power. Remove theiPod/iPhone, and turn the unit off and on again.START≥ The system is being restarted during the firmware update.Please do not turn off power.FINISH≥ The firmware update is completed.NOT CONDITIONAL≥ The requested operation cannot be conducted.On the televisionOn the unit’s display