Panasonic SA-BTT405P Service Manual

3412.3. Disassembly Procedure12.3.1. Top Panel1.Remove 6 Screws (A).2.Open the both ends at the rear side of the Top Panel inthe direction of arrow (1), then pull up the top panel in thedirection of arrow (2) to remove it.12.3.2. Front Panel Unit12.3.2.1. Tray Ornament1.Insert paper clips, etc. into the hole on the unit bottom,then slide the gear in the direction of arrow (1) to eject thetray slightly.2.Unlock 2 tabs.3.Pull the Tray Ornament in direction of arrow (2).12.3.2.2. Front Panel Unit1.Disconnect the connector (A) and FFC cable.2.Unlock 5 tabs (A) - (E) turn.3.Pull the Front Panel in the direction of your side.12.3.3. Front P.C.B.Unit and NFC P.C.B Unit1.Remove the 5 Screws (A).2.Remove the 2 Metal Plates .3.Pull out the Front P.C.B. Unit,then remove the connector (A).Top Panel(2)(1)(1)Disc TrayPaper clip,etc.Tray Ornament(1)TabDisc Tray(2)Tab(E)Tab(A)Tab(B)Front PanelConnector(A)FFCScrew (A)Screw (A)Screw (A)3612.3. Disassembly Procedure12.3.1. Top Panel1. Remove the 6 screws (A).2. Slide Top Panel rearward and open the both ends at rearside of the Top Panel a little and lift the Top Panel in thedirection of the arrows.12.3.2. Front Panel Unit12.3.2.1. Tray Ornament1. Insert paper clips, etc. into the hole on the bottom of themain unit, and slide the lever in the direction of (1) to ejectthe disc tray slightly.2. Unlock 2 tabs turn,Pull the Tray Ornament in direction of (2).12.3.2.2. Front Panel Unit1. Detach the lead wires fixed at hooking part of the BodyChassis.2. Remove the connector (A) and flex (A).3. Unlock 5 tabs (A) - (E) turn.Pull with the Front Panel Unit in the direction of (1).12.3.3. Front P.C.B. Unit / NFC P.C.B. Unit1. Remove the 5 screws (A).2. Remove the 2 Metal Plates.3. Pull out the Front P.C.B. Unit,then remove the connector (A).3612.3. Disassembly Procedure12.3.1. Top Panel1. Remove the 6 screws (A).2. Slide Top Panel rearward and open the both ends at rearside of the Top Panel a little and lift the Top Panel in thedirection of the arrows.12.3.2. Front Panel Unit12.3.2.1. Tray Ornament1. Insert paper clips, etc. into the hole on the bottom of themain unit, and slide the lever in the direction of (1) to ejectthe disc tray slightly.2. Unlock 2 tabs turn,Pull the Tray Ornament in direction of (2).12.3.2.2. Front Panel Unit1. Detach the lead wires fixed at hooking part of the BodyChassis.2. Remove the connector (A) and flex (A).3. Unlock 5 tabs (A) - (E) turn.Pull with the Front Panel Unit in the direction of (1).12.3.3. Front P.C.B. Unit / NFC P.C.B. Unit1. Remove the 5 screws (A).2. Remove the 2 Metal Plates.3. Pull out the Front P.C.B. Unit,then remove the connector (A).