Panasonic RX-ES29 Operating Instructions Manual

Also see for RX-ES29: Operating instructions Operating instructions

Contents

Panasonic RX-ES29 Operating Instructions Manual Manual pdf 10 page image

RQT796710Cassette Tape Play[1] Press [< DECK] to open the deck.(The unit comes on.)Load a cassette and close thedeck by hand.A: Side to be played back facingup.B: Insert the cassette with theexposed tape facing you.[2] Press [1TAPE] to start play.[3] Press [+, – VOLUME] to adjust volume.* when using AC power.Cassette Tape RecordingBefore RecordingNotes:≥ Use household AC power or new batteries when recording toavoid poor recordings caused by the batteries running down.≥ Televisions can cause interference to recordings made onthis unit if they are too close to each other.Selection of tapesUse normal position tapes.High position and metal position tapes can be played, but theunit will not be able to record or erase correctly.Volume and sound quality in recording≥ Recording level is set automatically.≥ Recordings are unaffected by changes to sound quality.To display the tape counter while recordingPress [DISPLAY].Each time you press the button in the CD or radio mode:To reset the tape counterPress [C.RESET].The counter resets to “000”.Erasure preventionThe illustration shows how to remove the tabs to preventrecording. To record on the tape again, cover as shown.A Side AB Tab for side “B”C Tab for side “A”D Adhesive tapeTo erase recordings1 Press [< DECK] to open the deck and insert the cassettewith the side to be erased facing up.2 Press [∫ TAPE/CD] to switch to TAPE mode.3 Press [¥/;].Recording CDsNormal recordingPreparation:Wind on the leader tape.[1] Press [< DECK] to open the deck.[2] Press [∫ TAPE/CD] to switch to CD mode.[3] Press [¥/;] to start recording.CD play and recording start at the same time.The cassette stops when the CD finishes.To Operationsstop play Press [∫ TAPE/CD].start one touch play* Press [1TAPE] when a cassette isloaded.fast-forward Press [5/+/FF]. On remotecontrol, press [5/FF].rewind Press [REW/–/6].On remote control, press[6/REW].R E WTAPE ⁄ CDVOLUMEABPresent state Present time Tape counter## ]n========== ]n,=====AB CAD